PRIVATE PILOT
Practical Test Standards ｆor AIRPLANE (Multi-Engine)
IV. AREA OF OPERATION: TAKEOFFS, LANDINGS, AND GO-AROUNDS
A. TASK: NORMAL AND CROSSWIND TAKEOFF AND CLIMB (AMEL and AMES)
NOTE: If a crosswind condition does not exist, the applicant's knowledge of crosswind elements shall be evaluated through oral testing.
REFERENCES: FAA-H-8083-3; POH/AFM.
Objective. To determine that the applicant:
1. Exhibits knowledge of the elements related to a normal and
crosswind takeoff, climb operations, and rejected takeoff procedures.
2. Positions the flight controls for the existing wind conditions.
3. Clears the area; taxies into the takeoff position and aligns the airplane on the runway center/takeoff path.
4. Retracts the water rudders as appropriate, (AMES) advances the throttles smoothly to takeoff power.
5. Establishes and maintains the most efficient planing/lift-off attitude and corrects for porpoising and skipping (AMES).
6. Lifts off at the recommended airspeed and accelerates to VY.
7. Establishes a pitch attitude that will maintain VY +10/-5 knots.
8. Retracts the landing gear, if appropriate, and flaps after a positive rate of climb is established.
9. Maintains takeoff power and VY +10/-5 knots to a safe maneuvering altitude.
10. Maintains directional control and proper wind-drift correction throughout the takeoff and climb.
11. Complies with noise abatement procedures.
12. Completes the appropriate checklist.
B. TASK: NORMAL AND CROSSWIND APPROACH AND LANDING (AMEL and AMES)
NOTE: If a crosswind condition does not exist, the applicant's knowledge of crosswind elements shall be evaluated through oral testing.
REFERENCES: FAA-H-8083-3; POH/AFM.
Objective. To determine that the applicant:
1. Exhibits knowledge of the elements related to a normal and crosswind approach and landing.
2. Adequately surveys the intended landing area (AMES).
3. Considers the wind conditions, landing surface, obstructions, and selects a suitable touchdown point.
4. Establishes the recommended approach and landing configuration and airspeed, and adjusts pitch attitude and power as required.
5. Maintains a stabilized approach and recommended airspeed, or in its absence, not more than 1.3 VSO, +10/-5 knots, with wind gust factor applied.
6. Makes smooth, timely, and correct control application during the roundout and touchdown.
7. Contacts the water at the proper pitch attitude (AMES).
8. Touches down smoothly at approximate stalling speed (AMEL).
9. Touches down at or within 400 feet (120 meters) beyond a specified point, with no drift, and with the airplane's longitudinal axis aligned with and over the runway center/landing path.
10. Maintains crosswind correction and directional control throughout the approach and landing sequence.
11. Completes the appropriate checklist.
C. TASK: SHORT-FIELD (CONFINED AREA--AMES) TAKEOFF AND MAXIMUM PERFORMANCE CLIMB (AMEL and AMES)
REFERENCES: FAA-H-8083-3; POH/AFM.
Objective. To determine that the applicant:
1. Exhibits knowledge of the elements related to a short-field (confined area AMES) takeoff and maximum performance climb.
2. Positions the flight controls for the existing wind conditions; sets the flaps as recommended.
3. Clears the area; taxies into takeoff position utilizing maximum available takeoff area and aligns the airplane on the runway center/take-off path.
4. Selects an appropriate take-off path for the existing conditions (AMES).
5. Applies brakes (if appropriate), while advancing the throttles smoothly to takeoff power.
6. Establishes and maintains the most efficient planing/lift-off attitude and corrects for porpoising and skipping (AMES).
7. Lifts off at the recommended airspeed, and accelerates to the recommended obstacle clearance airspeed or VX.
8. Establishes a pitch attitude that will maintain the recommended obstacle clearance airspeed, or VX,+10/-5 knots, until the obstacle is cleared, or until the airplane is 50 feet (20 meters) above the surface.
9. After clearing the obstacle, establishes the pitch attitude for VY accelerates to VY, and maintains VY, +10/-5 knots, during the climb.
10. Retracts the landing gear, if appropriate, and flaps after clear of any obstacles or as recommended by manufacturer.
11. Maintains takeoff power and VY +10/-5 knots to a safe maneuvering altitude.
12. Maintains directional control and proper wind-drift correction throughout the takeoff and climb.
13. Completes the appropriate checklist.
D. TASK: SHORT-FIELD APPROACH (CONFINED AREA--AMES) AND LANDING (AMEL AND AMES)
REFERENCES: FAA-H-8083-3; POH/AFM.
Objective. To determine that the applicant:
1. Exhibits knowledge of the elements related to a short-field (confined area AMES) approach and landing.
2. Adequately surveys the intended landing area (AMES).
3. Considers the wind conditions, landing surface, obstructions, and selects the most suitable touchdown point.
4. Establishes the recommended approach and landing configuration and airspeed; adjusts pitch attitude and power as required.
5. Maintains a stabilized approach and recommended approach airspeed, or in its absence not more than 1.3 VSO, +10/-5 knots, with wind gust factor applied.
6. Makes smooth, timely, and correct control application during the roundout and touchdown.
7. Selects the proper landing path, contacts the water at the minimum safe airspeed with the proper pitch attitude for the surface conditions (AMES).
8. Touches down smoothly at minimum control airspeed (AMEL).
9. Touches down at or within 200 feet (60 meters) beyond a specified point, with no side drift, minimum float, and with the airplane's longitudinal axis aligned with and over the runway center/landing path.
10. Maintains crosswind correction and directional control throughout the approach and landing sequence.
11. Applies brakes, (AMEL) or elevator control (AMES), as necessary, to stop in the shortest distance consistent with safety.
12. Completes the appropriate checklist.
G. TASK: GLASSY WATER TAKEOFF AND CLIMB (AMES)
NOTE: If a glassy water condition does not exist, the applicant shall be evaluated by simulating the TASK.
REFERENCES: FAA-H-8083-3; POH/AFM.
Objective. To determine that the applicant:
1. Exhibits knowledge of the elements related to glassy water takeoff and climb.
2. Positions the flight controls and flaps for the existing conditions.
3. Clears the area; selects an appropriate takeoff path considering surface hazards and/or vessels and surface conditions.
4. Retracts the water rudders as appropriate; advances the throttle smoothly to takeoff power.
5. Establishes and maintains an appropriate planing attitude, directional control, and corrects for porpoising, skipping, and
increases in water drag.
6. Utilizes appropriate techniques to lift seaplane from the water considering surface conditions.
7. Establishes proper attitude/airspeed, and accelerates to VY, +10/-5 knots during the climb.
8. Retracts the landing gear, if appropriate, and flaps after a positive rate of climb is established.
9. Maintains takeoff power and VY +10/-5 knots to a safe maneuvering altitude.
10. Maintains directional control and proper wind-drift correction throughout takeoff and climb.
11. Completes the appropriate checklist.
H. TASK: GLASSY WATER APPROACH AND LANDING (AMES)
NOTE: If a glassy water condition does not exist, the applicant shall be evaluated by simulating the TASK.
REFERENCES: FAA-H-8083-3; POH/AFM.
Objective. To determine that the applicant:
1. Exhibits knowledge of the elements related to glassy water approach and landing.
2. Adequately surveys the intended landing area.
3. Considers the wind conditions, water depth, hazards, surrounding terrain, and other watercraft.
4. Selects the most suitable approach path and touchdown area.
5. Establishes the recommended approach and landing configuration and airspeed, and adjusts pitch attitude and power as required.
6. Maintains a stabilized approach and the recommended approach airspeed, +10/-5 knots and maintains a touchdown pitch attitude and descent rate from the last altitude reference until touchdown.
7. Makes smooth, timely, and correct power and control adjustments to maintain proper pitch attitude and rate of descent to touchdown.
8. Contacts the water in the proper pitch attitude, and slows to idle taxi speed.
9. Maintains crosswind correction and directional control throughout the approach and landing sequence.
10. Completes the appropriate checklist.
I. TASK: ROUGH WATER TAKEOFF AND CLIMB (AMES)
NOTE: If a rough water condition does not exist, the applicant shall be evaluated by simulating the TASK.
REFERENCES: FAA-H-8083-3; POH/AFM.
Objective. To determine that the applicant:
1. Exhibits knowledge of the elements related to rough water takeoff and climb.
2. Positions the flight controls and flaps for the existing conditions.
3. Clears the area; selects an appropriate takeoff path considering wind, swells, surface hazards, and/or vessels.
4. Retracts the water rudders as appropriate; advances the throttle smoothly to takeoff power.
5. Establishes and maintains an appropriate planing attitude, directional control, and corrects for porpoising, skipping, or excessive bouncing.
6. Lifts off at minimum airspeed and accelerates to VY, +10/-5 knots before leaving ground effect.
7. Retracts the landing gear, if appropriate, and flaps after a positive rate of climb is established.
8. Maintains takeoff power and VY +10/-5 knots to a safe maneuvering altitude.
9. Maintains directional control and proper wind-drift correction throughout takeoff and climb.
10. Completes the appropriate checklist.
J. TASK: ROUGH WATER APPROACH AND LANDING (AMES)
NOTE: If a rough water condition does not exist, the applicant shall be evaluated by simulating the TASK.
REFERENCES: FAA-H-8083-3; POH/AFM.
Objective. To determine that the applicant:
1. Exhibits knowledge of the elements related to rough water approach and landing.
2. Adequately surveys the intended landing area.
3. Considers the wind conditions, water, depth, hazards, surrounding terrain, and other watercraft.
4. Selects the most suitable approach path, and touchdown area.
5. Establishes the recommended approach and landing configuration and airspeed, and adjusts pitch attitude and power as required.
6. Maintains a stabilized approach and the recommended approach airspeed, or in its absence not more than 1.3 VSO +10/-5 knots with wind gust factor applied.
7. Makes smooth, timely, and correct power and control application during the roundout and touch down.
8. Contacts the water in the proper pitch attitude, and at the proper airspeed, considering the type of rough water.
9. Maintains crosswind correction and directional control throughout the approach and landing sequence.
10. Completes the appropriate checklist.
K. TASK: GO-AROUND/REJECTED LANDING (AMEL and AMES)
REFERENCES: FAA-H-8083-3; POH/AFM.
Objective. To determine that the applicant:
1. Exhibits knowledge of the elements related to a go-around/rejected landing.
2. Makes a timely decision to discontinue the approach to landing.
3. Applies takeoff power immediately and transitions to climb pitch attitude for VY and maintains VY +10/-5 knots.
4. Retracts the flaps, as appropriate.
5. Retracts the landing gear, if appropriate, after a positive rate of climb is established.
6. Maneuvers to the side of the runway/landing area to clear and avoid conflicting traffic.
7. Maintains takeoff power and VY +10/-5 knots to a safe maneuvering altitude.
8. Maintains directional control and proper wind-drift correction throughout the climb.
9. Completes the appropriate checklist.
